Cisco Cisco IPS 4345 Sensor 릴리즈 노트

You can use the sync command to store these settings in NVRAM so they are maintained across 
boots. Otherwise, you must enter this information each time you want to boot an image from 
ROMMON.

Download and install the system image.

rommon> tftp

To avoid corrupting the system image, do not remove power from the IPS 4270-20 while the system 
image is being installed.

If the network settings are correct, the system downloads and boots the specified image on the 
IPS 4270-20. Be sure to use the IPS 4270-20 image.

For the procedure for locating software, see 

For a list of supported TFTP servers, see 

.

For a list of the specific IPS software files, see 

For the procedure for initializing the sensor with the setup command, see 

.

You can install the IPS 4345 and IPS 4360 system image by using the ROMMON on the appliance to 
TFTP the system image on to the compact flash device.

This procedure is for IPS 4345, but is also applicable to IPS 4360. The system image for IPS 4360 has 
“4360” in the filename. 

To install the IPS 4345 and IPS 4360 system image, follow these steps:

Download the IPS 4345 system image file to the tftp root directory of a TFTP server that is accessible 
from your IPS 4345. 

Make sure you can access the TFTP server location from the network connected to the Ethernet 
port of your IPS 4345.

Boot the IPS 4345.

Booting system, please wait... 

CISCO SYSTEMS