Cisco Cisco IPS 4520 Sensor 릴리즈 노트

network-participation full

exit

[0] Go to the command prompt without saving this config.

[1] Return to setup without saving this config.

[2] Save this configuration and exit setup.

[3] Continue to Advanced setup.

Enter 

 to save the configuration (or 

 to continue with advanced setup using the CLI).

Enter your selection[2]: 2 

Configuration Saved.

If you changed the time setting, enter 

 to reboot the sensor.

The currently supported Cisco IPS appliances are the IPS 4240, IPS 4255, and IPS 4260 [IPS 7.0(x) and 
later and IPS 7.1(5) and later], IPS 4270-20 [IPS 7.1(3) and later], IPS 4345 and IPS 4360 [IPS 7.1(3) 
and later], IPS 4510 and IPS 4520 [IPS 7.1(4) and later]. 

Adding new subinterfaces is a two-step process. You first organize the interfaces when you edit the 
virtual sensor configuration. You then choose which interfaces and subinterfaces are assigned to which 
virtual sensors.

To continue with advanced setup for the appliance, follow these steps:

Log in to the appliance using an account with administrator privileges.

Enter the 

 command. The System Configuration Dialog is displayed. Press Enter or the spacebar 

to skip to the menu to access advanced setup. 

Enter 

to access advanced setup. 

Specify the Telnet server status. The default is disabled.

Specify the web server port. The web server port is the TCP port used by the web server (1 to 65535). 
The default is 443.

The web server is configured to use TLS/SSL encryption by default. Setting the port to 80 does 
not disable the encryption.

Enter 

 to modify the interface and virtual sensor configuration and to see the current interface 

configuration.

Current interface configuration

 Command control: Management0/0

 Unassigned:

  Promiscuous:

   GigabitEthernet0/0

   GigabitEthernet0/1