Cisco Cisco ASA 5580 Adaptive Security Appliance 문제 해결 가이드
Clustering Disabled on Slave ASA
(RPC_SYSTEMERROR)
(RPC_SYSTEMERROR)
Document ID: 116108
Contributed by Prapanch Ramamoorthy, Cisco TAC Engineer.
May 09, 2013
May 09, 2013
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Background Information
Problem
Solution 1
Solution 2
Related Information
Prerequisites
Requirements
Components Used
Conventions
Background Information
Problem
Solution 1
Solution 2
Related Information
Introduction
This document describes how to resolve an error message that might appear when you attempt to add a new
slave Adaptive Security Appliance (ASA) unit to an existing cluster of ASAs.
slave Adaptive Security Appliance (ASA) unit to an existing cluster of ASAs.
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
Basic knowledge of clustering.
•
Basic knowledge of how to configure clustering on the Adaptive Security Appliance (ASA).
•
Basic knowledge of the Secure Socket Layer (SSL) handshake.
•
Components Used
The information in this document is based on these software and hardware versions:
ASA software version 9.0 or later.
•
ASA 5580 or ASA5585−X series appliances.
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.