Cisco Cisco Aironet 1530i Outdoor Access Point 전단
Contents
Introduction
Prerequisites
Components Used
Configuration
Network Diagram
Configuration 1
Wired Root AP mesh configuration
Mesh Access Point(MAP) configuration
Slave AP-- Daisy Chain Configuration
Configuration 2
Wired Root AP configuration
Master MAP AP configuration
Slave RAP connected to the Master AP and the remote switch.
Verify
Troubleshoot
Introduction
This document lists 2 methods to successfully setup the 1532's with daisy chaining and allow
ethernet bridging of a remote switch's traffic to flow through to the core network.
ethernet bridging of a remote switch's traffic to flow through to the core network.
Prerequisites
Controller running 8.0.120.0 and up.
Minimum of 2 1532 outdoor AP's(Access Point). You can use any other model of AP as the wired
root, but for daisy chaining you have to use 2 1532's, of course.
root, but for daisy chaining you have to use 2 1532's, of course.
Before starting any of this configuration, please make sure that the remote switch is not connected
to the Slave RAP(Root Access Point) until the configuration on the mesh network is complete and
verified to be correct. If you do not do this, there is a high probability that spanning tree will take
down the entire mesh network that is connected to the RAP. It will block the root ap switch port
and drop all the children connected to it. This can create a whole new set of issues due to the re-
convergence of the mesh network. Potentially causing an extended outage and a lot of frustration.
to the Slave RAP(Root Access Point) until the configuration on the mesh network is complete and
verified to be correct. If you do not do this, there is a high probability that spanning tree will take
down the entire mesh network that is connected to the RAP. It will block the root ap switch port
and drop all the children connected to it. This can create a whole new set of issues due to the re-
convergence of the mesh network. Potentially causing an extended outage and a lot of frustration.
Components Used
2504 Wireless LAN Controller
●
2702 as the wired RAP
●
2 1532's to daisy chain
●
2 switches (3750's in my lab), one core, one remote.
●
2 vlans.
●
1107 is native and what the AP's connect to the controller on.
●
12 is remote wired client vlan.
●