Cisco Cisco Aironet 1530i Outdoor Access Point 설치 가이드

The access point must be grounded before connecting power.

This equipment must be externally grounded using a customer-supplied ground wire 
before power is applied. Contact the appropriate electrical inspection authority or an 
electrician if you are uncertain that suitable grounding is available. Statement 366

Installation of the equipment must comply with local and national electrical codes. 
Statement 1074

In all outdoor installations and when powering the access point with AC power, you must follow these 
instructions to properly ground the access point:

If using insulated 6-AWG copper ground wire, strip the insulation as required for the 
grounding lug.

Use the appropriate crimping tool to crimp the bare 6-AWG copper ground wire to the 
supplied grounding lug.

The grounding lug and hardware used must comply with local and national electrical 
codes.

Open the electrical joint compound (supplied), and apply a liberal amount over the metal 
surface where the ground strap screw holes are located (see 

).

Connect the grounding lug to the access point grounding screw holes (see 

supplied two Phillips head screws (M4 x 10 mm) with lock washers. Tighten the grounding 
screw to 22 to 24 in. lbs (2.49 to 2.71 Nm).

If necessary, strip the other end of the ground wire and connect it to a reliable earth ground, 
such as a grounding rod or an appropriate grounding point on a metal streetlight pole that is 
grounded.