Cisco Cisco ASA 5510 Adaptive Security Appliance 문제 해결 가이드

Contributed by Atri Basu, Cisco TAC Engineer.
Mar 23, 2015

Introduction
Prerequisites
     Requirements
     Components Used
     Conventions
Problem
Solution
     Use the Appropriate URL
     Change the Port on which Each Service Listens
        Change the Port for the HTTPS Server Service Globally
        Change the the Port for the WebVPN Service Globally
Related Information

This document describes how to access the Cisco Adaptive Security Device Manager (ASDM) and the
WebVPN portal when they are both enabled on the same interface of the Cisco 5500 Series Adaptive Security
Appliance (ASA).

Note: This document is not applicable for the Cisco 500 Series PIX Firewall, because it does not support
WebVPN.

Cisco recommends that you have knowledge of these topics:

WebVPN configuration  Refer to the Clientless SSL VPN (WebVPN) on ASA Configuration
Example for more information. 

• 

Basic configuration required in order to launch ASDM  Refer to the Using ASDM section of
the Cisco ASA Series ASDM Configuration Guide, 7.0 for more information.

• 

The information in this document is based on the Cisco 5500 Series ASA.

The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.