Cisco Cisco ASA for Nexus 1000V Series Switch 문제 해결 가이드
ASA 8.x/ASDM 6.x: Add New VPN Peer Information
in an Existing Site−to−Site VPN using ASDM
in an Existing Site−to−Site VPN using ASDM
Document ID: 113290
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Backround information
ASDM Configuration
Create a New Connection Profile
Edit the Existing VPN Configuration
Verify
Troubleshoot
IKE Initiator unable to find policy: Intf test_ext, Src: 172.16.1.103, Dst: 10.1.4.251
Related Information
Prerequisites
Requirements
Components Used
Conventions
Backround information
ASDM Configuration
Create a New Connection Profile
Edit the Existing VPN Configuration
Verify
Troubleshoot
IKE Initiator unable to find policy: Intf test_ext, Src: 172.16.1.103, Dst: 10.1.4.251
Related Information
Introduction
This document provides information about the configurational changes to make when a new VPN peer is
added to the existing site−to−site VPN configuration using Adaptive Security Device Manager (ASDM). This
is required in these scenarios:
added to the existing site−to−site VPN configuration using Adaptive Security Device Manager (ASDM). This
is required in these scenarios:
The Internet Service Provider (ISP) has been changed and a new set of public IP range is used.
•
A complete re−design of the network at a site.
•
The device used as VPN gateway at a site is migrated to a new device with a different public IP
address.
address.
•
This document assumes that the site−to−site VPN is already configured properly and works fine. This
document provides the steps to follow in order to change a VPN peer information in the L2L VPN
configuration.
document provides the steps to follow in order to change a VPN peer information in the L2L VPN
configuration.
Prerequisites
Requirements
Cisco recommends that you have knowledge of this topic:
ASA Site−to−Site VPN configuration example
•
Components Used
The information in this document is based on these software and hardware versions:
Cisco Adapative Security Appliance 5500 series with software version 8.2 and later
•
Cisco Adapative Security Device Manager with software version 6.3 and later
•