Cisco Cisco ASA 5520 Adaptive Security Appliance 기술 매뉴얼
Configure the ASA for Dual Internal Networks
Document ID: 119195
Contributed by Dinkar Sharma, Bratin Saha, and Prashant Joshi, Cisco
TAC Engineers.
Aug 05, 2015
TAC Engineers.
Aug 05, 2015
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Background Information
Configure
Network Diagram
ASA 9.x Configuration
Allow Inside Hosts Access to Outside Networks with PAT
Router B Configuration
Verify
Connection
Troubleshoot
Syslogs
Packet Tracers
Capture
Related Information
Prerequisites
Requirements
Components Used
Conventions
Background Information
Configure
Network Diagram
ASA 9.x Configuration
Allow Inside Hosts Access to Outside Networks with PAT
Router B Configuration
Verify
Connection
Troubleshoot
Syslogs
Packet Tracers
Capture
Related Information
Introduction
This document describes how to configure a Cisco Adaptive Security Appliance (ASA) that runs software
Version 9.x for the use of two internal networks.
Version 9.x for the use of two internal networks.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
The information in this document is based on the Cisco ASA that runs software Version 9.x.
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.