Cisco Cisco ASA 5520 Adaptive Security Appliance 문제 해결 가이드
ASA: Receiving and Transmitting Jumbo Ethernet
Frames
Frames
Document ID: 115003
Contributed by Jay Johnston, Cisco TAC Engineer.
Oct 01, 2012
Oct 01, 2012
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Jumbo frame support on the ASA
Prerequisites
Requirements
Components Used
Conventions
Jumbo frame support on the ASA
What if the ASA is not configured for jumbo frames and it receives a jumbo frame?
What if the ASA successfully receives a jumbo frame but attempts to send it out an interface with a lower
MTU?
Related Information
What if the ASA successfully receives a jumbo frame but attempts to send it out an interface with a lower
MTU?
Related Information
Introduction
This document provides information how the Adaptive Security Appliance (ASA) receives and transmits
jumbo ethernet frames.
jumbo ethernet frames.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
This document is not restricted to specific software and hardware versions.
Conventions
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Jumbo frame support on the ASA
Enabling jumbo frame support requires specific Adaptive Security Appliance (ASA) hardware and software
versions, as well as a reboot. For more information on the supported models and versions, as well as how to
enable jumbo frames, refer to the ASA 8.4 configuration guide section, Enabling Jumbo Frame Support
(Supported Models).
versions, as well as a reboot. For more information on the supported models and versions, as well as how to
enable jumbo frames, refer to the ASA 8.4 configuration guide section, Enabling Jumbo Frame Support
(Supported Models).
Note that after enabling jumbo frame support and rebooting the ASA, these additional actions should be taken
to make full use of jumbo frames:
to make full use of jumbo frames: