Cisco Cisco ASA for Nexus 1000V Series Switch 기술 매뉴얼

Introduction
 Prerequisites
      Requirements
      Components Used
      Conventions
 Procedure
 Verify
 Troubleshoot
      How to copy SSL certificates from one ASA to another
 Related Information

The procedure in this document is an example and can be used as a guideline with any certificate vendor or
your own root certificate server. Special certificate parameter requirements are sometimes required by your
certificate vendor, but this document is intended to provide the general steps required to renew an SSL
certificate and install it on an ASA that uses 8.0 software.

There are no specific requirements for this document.

This procedure pertains to ASA versions 8.x with ASDM version 6.0(2) or later.

The procedure in this document is based on a valid configuration with a certificate installed and used for SSL
VPN access. This procedure does not impact your network as long as the current certificate is not deleted.
This procedure is a step−by−step process on how to issue a new CSR for a current certificate with the same
root certificate that issued the original root CA.

The information in this document was created from the devices in a specific lab environment. If your network
is live, make sure that you understand the potential impact of any command.

Refer to the Cisco Technical Tips Conventions for more information on document conventions.

Complete these steps: