Cisco Cisco ASA for Nexus 1000V Series Switch 문제 해결 가이드
7
Power−on and ATZ Reset Software Defaults
8
AT Command Set Recognition
Initialization String
The initialization string entered for this configuration has these characteristics:
AT&FS0=1&C1&D2&H0&R1&B1&M4&K0&N6&W
AT Command
Description
&F0
Set to Factory Defaults (no Flow Control)
S0=1
Auto Answer on first ring
&C1
Uses the actual state of the carrier from
the remote modem for the Data Carrier
Detect (recommended)
the remote modem for the Data Carrier
Detect (recommended)
&D2
DTR going off triggers modem
disconnect, sends OK result code, and
disables auto answer while DTR is OFF.
(default)
disconnect, sends OK result code, and
disables auto answer while DTR is OFF.
(default)
&R1
In synchronous mode, CTS is always on,
and RTS is ignored
and RTS is ignored
&M4
ARQ/Normal Mode
&K0
Disable Data Compression
&N6
Highest Link Speed (DCE rate) is 9600
bps
bps
&W
Store configuration to NVRAM
&Q1
Selects synchronous connect mode with
async off−line command mode
async off−line command mode
Cable Pinouts for RJ−45 to DB−9 or DB−25
RJ−45 Rolled (Console) Cable Pinouts