Cisco Cisco Aironet 1530i Outdoor Access Point 릴리즈 노트
3
Release Notes for Cisco Aironet Access Points and Bridges for Cisco IOS Release 15.3(3)JA1
OL-31537-01
System Requirements
Step 2
Click Support. The Support and Documentation page appears.
Step 3
Under the Select a Product Name, click Wireless. The Product/Technology Support page appears.
Step 4
Under the Make a Selection to Continue section, click Access Point. Products and Access Point are
highlighted.
highlighted.
Step 5
Select the access point model for which you need the information. For example, click the Cisco Aironet
1260 series. A list of documents appears.
1260 series. A list of documents appears.
Step 6
Click Configure. A list of configuration documents appears.
Step 7
Click Cisco IOS Software Configuration Guide for Cisco Aironet Access Points, 15.3(3)JA1.
Step 8
Navigate to the Managing Firmware and Software chapter.
For information on Cisco IOS software, click this link to browse to the Cisco IOS Software Center on
Cisco.com:
Cisco.com:
The new Cisco IOS software is supported only in these versions of 1550 series:
Note
AP 1550 does not support 64 MB Cisco IOS Release starting from 15.2(4)JA1 in autonomous mode.
Converting a Lightweight Access Point Back to Autonomous Mode
You can convert an access point from lightweight mode back to autonomous mode by loading a Cisco
IOS Release that supports autonomous mode. If the access point is associated with a controller, you can
use the controller to load the Cisco IOS release. If the access point is not associated with a controller,
you can load the Cisco IOS release using TFTP. The image files and their supported access points are
listed in
IOS Release that supports autonomous mode. If the access point is associated with a controller, you can
use the controller to load the Cisco IOS release. If the access point is not associated with a controller,
you can load the Cisco IOS release using TFTP. The image files and their supported access points are
listed in
.
Note
Conversions from an 8.0 Wireless LAN Controller unified release AP image to autonomous 15.3(3)
k9w7 image will get aborted with a message "AP image integrity check failed." To overcome this, load
any previous autonomous k9w7 image and then upgrade to the 15.3(3) JAB k9w7 images.
k9w7 image will get aborted with a message "AP image integrity check failed." To overcome this, load
any previous autonomous k9w7 image and then upgrade to the 15.3(3) JAB k9w7 images.
Version
First VID with 128 MB
1552E
VID 04
1552EU
VID 01 (all)
1552I
VID 03
1552H
VID 04
1552S
VID 01 (all)