Cisco Cisco 2504 Wireless Controller 문제 해결 가이드
Resetting the LWAPP Configuration on a
Lightweight AP (LAP)
Lightweight AP (LAP)
Document ID: 99763
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Manually Configuring the LAP
Resetting the LWAPP Configuration on the LAP
Behavior in WLC release prior to 6.0.188.0
Behavior in WLC release 6.0.188.0 and later
Reset LAP through WLC
How to Disable the Reset Button on the AP Registered to the Controller
Verify
Troubleshoot
Related Information
Prerequisites
Requirements
Components Used
Conventions
Manually Configuring the LAP
Resetting the LWAPP Configuration on the LAP
Behavior in WLC release prior to 6.0.188.0
Behavior in WLC release 6.0.188.0 and later
Reset LAP through WLC
How to Disable the Reset Button on the AP Registered to the Controller
Verify
Troubleshoot
Related Information
Introduction
This document explains how to manually set or reset the Lightweight Access Point Protocol (LWAPP) static
configuration information on a Lightweight Access Point (LAP).
configuration information on a Lightweight Access Point (LAP).
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
Basic knowledge of the configuration of LAPs and Cisco WLCs
•
Basic knowledge of LWAPP/CAPWAP
•
Components Used
The information in this document is based on these software and hardware versions:
Cisco 4400 WLC that runs firmware release 4.1.181.0
•
Cisco 4400 WLC that runs firmware release 7.0.116.0
•
Cisco Aironet 1240AG Series AP that runs version 12.3(7)JX5
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.