Cisco Cisco 5508 Wireless Controller 기술 매뉴얼
Port−based Authentication with a LAP and ACS 5.2
Configuration Example
Configuration Example
Document ID: 113559
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Background Information
Configure
Network Diagram
Assumptions
Configuration Steps
Configure LAP
Prerequisites
Requirements
Components Used
Conventions
Background Information
Configure
Network Diagram
Assumptions
Configuration Steps
Configure LAP
Configure Switch
Configure RADIUS Server
Configure Network Resources
Configure Users
Define Policy Elements
Apply Access Policies
Verify
Troubleshoot
Related Information
Configure Network Resources
Configure Users
Define Policy Elements
Apply Access Policies
Verify
Troubleshoot
Related Information
Introduction
This document describes how to configure a Lightweight Access Point (LAP) as an 802.1x supplicant in order
to authenticate against a RADIUS Server such as an Access Control Server (ACS) 5.2.
to authenticate against a RADIUS Server such as an Access Control Server (ACS) 5.2.
Prerequisites
Requirements
Make sure that you meet these requirements before you attempt this configuration:
Have basic knowledge of the Wireless LAN Controller (WLC) and LAPs.
•
Have functional knowledge of the AAA server.
•
Have thorough knowledge of wireless networks and wireless security issues.
•
Components Used
The information in this document is based on these software and hardware versions:
Cisco 5508 WLC that runs firmware release 7.0.220.0
•
Cisco 3502 Series LAP
•