Cisco Cisco 5520 Wireless Controller 기술 매뉴얼

Introduction
 Prerequisites
      Requirements
      Components Used
      Conventions
 Background Information
      Cisco Aironet 1520 Series Lightweight Outdoor Mesh AP
      Root Access Points
      Mesh Access Points
      Cisco Adaptive Wireless Path Protocol Wireless Mesh Routing
      Features Not Supported on Mesh Networks
 Configure
      Network Diagram
      Configurations
      Add the MAC Address of the Mesh AP to the MAC Filter of the Controller

Define the Role (RAP or MAP) of the mesh Access Point
Verify
 Troubleshoot
      Troubleshooting Commands
 Related Information

This document provides a basic configuration example on how to configure Point−to−Point wireless bridging
deployment mode using the Mesh Network solution from Cisco Wireless LAN Controller Releases 5.2 and
later.

Refer to Wireless LAN Controller Mesh Network Configuration Example for more information and for the
configuration example of WLC Releases 5.1 and earlier.

This example uses two lightweight access point (LAPs). One LAP operates as a Root Access Point (RAP), the
other LAP operates as a Mesh Access Point (MAP), and they are connected to a Cisco Wireless LAN
Controller (WLC). The RAP is connected to the WLC through a Cisco Catalyst switch.

Cisco recommends that you have knowledge of these topics:

Basic knowledge of the configuration of LAPs and Cisco WLCs

• 

Basic knowledge of Control And Provisioning of Wireless Access Points (CAPWAP)

• 

Knowledge of the configuration of an external DHCP server and/or domain name server (DNS)

•