Cisco Cisco 5508 Wireless Controller 기술 참조
Overriding LAN port settings will only apply to this AP and not the remaining APs in the AP Group. Overriding
of RLAN is not supported at AP level.
of RLAN is not supported at AP level.
Note
Configuring AIR-AP1810W (Wall Plate) to OfficeExtend AP
One can assemble and configure an AIR-AP1810W to operate as an OfficeExtend Access Point similar to the dedicated AIR-OEAP1810.
To assemble the AIR-AP10810W and use it as an OfficeExtend Access point, the following accessories can be ordered:
1
AIR-OEAP1810-CRD (Cradle Kit)–The Cradle Kit is sold separately and includes the RJ-45 Jumper cable, back cover for the
Access Point and the Cradle for seating the Access Point.
Access Point and the Cradle for seating the Access Point.
2
AIR-PWD-D=(Cisco Local Power Supply).
It is not a requirement to have the AIR-OEAP1810CRD (Cradle Kit) for the AIR-AP1810W to operate
as a OfficeExtend but if you would like the AIR-AP1810W to have the same look and feel and place it
on the desk, the above accessory options are recommended.
as a OfficeExtend but if you would like the AIR-AP1810W to have the same look and feel and place it
on the desk, the above accessory options are recommended.
Note
To do the assembly, follow the steps below:
1
Insert the jumper cable with one end to the POE port and the other end to the Pass Thru port at the back of the AIR-AP1810W
2
Install the Back Cover on the AIR-AP1810W. Before installing the back cover, take a note of the MAC address as it will be
required to identify and configure the AIR-AP1810W to operate as an OfficeExtend
required to identify and configure the AIR-AP1810W to operate as an OfficeExtend
19