Cisco Cisco 5520 Wireless Controller 디자인 가이드
1-16
Book Title
OL-xxxxx-xx
Chapter 1 Cisco Adaptive wIPS Management Deployment Guide, Release 8.0
Cisco Adaptive wIPS Introduction
In the above deployment example, four wIPS Access Points are deployed around the edges of the
building to provide security monitoring around the periphery of the physical building. In addition, a
wIPS Access Point is deployed in the center of the building to provide security-monitoring coverage
inside the building.
building to provide security monitoring around the periphery of the physical building. In addition, a
wIPS Access Point is deployed in the center of the building to provide security-monitoring coverage
inside the building.
Access Point Density Recommendations
As stated above, the square footage of access point coverage can be measured based on frequency and
environment, but with the newer wIPS modes, other factors also contribute to wIPS access point density
recommendations. All access point modes can monitor the same distance, but due to the reasons below,
it is recommended to deploy each mode with a different density.
environment, but with the newer wIPS modes, other factors also contribute to wIPS access point density
recommendations. All access point modes can monitor the same distance, but due to the reasons below,
it is recommended to deploy each mode with a different density.
Access Points in local mode with wIPS are geared towards serving clients. For local mode with wIPS
deployments, it is recommended for every access point be put in local mode with wIPS.
deployments, it is recommended for every access point be put in local mode with wIPS.
For monitor mode access points, we recommend that a ratio of 1:5 local mode to monitor mode access
points.
points.
Finally for the WSM module, there is a single radio monitoring all channels on both the 2.4 GHz and 5
GHz band. Since radio has additional channels to scan, it is recommended that the WSM module be
deployed with a 2:5 density to speed up detection time.
GHz band. Since radio has additional channels to scan, it is recommended that the WSM module be
deployed with a 2:5 density to speed up detection time.