Cisco Cisco NAC Appliance 4.6 릴리즈 노트
58
Release Notes for Cisco NAC Appliance, Version 4.6(1)
OL-19353-01
New Installation of Release 4.6(1)
New Installation of Release 4.6(1)
The following steps summarize how to perform new CD software installation of release 4.6(1) on
supported Cisco NAC Appliance hardware platforms (see
supported Cisco NAC Appliance hardware platforms (see
for additional support details).
To upgrade or re-image a Cisco NAC Network Module, refer to the instructions in
.
To upgrade on an existing NAC Appliance, refer to the instructions in
.
For New Installation:
With release 4.6(1), installation occurs in two phases:
1.
The software is installed from the CD, and when complete, the CD is ejected from the appliance.
2.
The admin logs in and performs the initial configuration.
Step 1
If you are going to perform a new installation but are running a previous version of Cisco Clean Access,
Cisco recommends backing up your current Clean Access Manager installation and saving the snapshot
on your local computer, as described in
Cisco recommends backing up your current Clean Access Manager installation and saving the snapshot
on your local computer, as described in
Step 2
Follow the instructions on your welcome letter to obtain product license files for your installation. See
for details. (If you are evaluating Cisco Clean Access, visit
to obtain an evaluation license.)
Step 3
Install the latest version of 4.6(1) on each Clean Access Server and Clean Access Manager, as follows:
a.
Log in to the
. You will likely be required to provide
your CCO credentials.
b.
Navigate to the Cisco NAC Appliance 4.6.1 subdirectory, download the latest 4.6(1) .ISO image,
(e.g. nac-4.6_1-K9.iso) and burn the image as a bootable disk to a CD-R.
(e.g. nac-4.6_1-K9.iso) and burn the image as a bootable disk to a CD-R.
Note
Cisco recommends burning the .ISO image to a CD-R using speeds 10x or lower. Higher
speeds can result in corrupted/unbootable installation CDs.
speeds can result in corrupted/unbootable installation CDs.
c.
Insert the CD into the CD-ROM drive of each installation server, and follow the instructions in the
auto-run installer.
auto-run installer.
Step 4
After software installation, access the Clean Access Manager web admin console by opening a web
browser and typing the IP address of the CAM as the URL. The Clean Access Manager License Form
will appear the first time you do this to prompt you to install your FlexLM license files.
browser and typing the IP address of the CAM as the URL. The Clean Access Manager License Form
will appear the first time you do this to prompt you to install your FlexLM license files.
Step 5
Install a valid FlexLM product license file for the Clean Access Manager (either evaluation, starter kit,
or individual license).
or individual license).
Step 6
At the admin login prompt, login with the web console username and password you configured when
you installed the Clean Access Manager.
you installed the Clean Access Manager.
Step 7
In the web console, navigate to Administration > CCA Manager > Licensing to install any additional
license files for your CASs, CAM HA pairs or CAS HA pairs. You must install the CAS license to add
the CASs to the CAM and an OOB CAS license to enable OOB features on the CAM.
license files for your CASs, CAM HA pairs or CAS HA pairs. You must install the CAS license to add
the CASs to the CAM and an OOB CAS license to enable OOB features on the CAM.