Cisco Cisco Email Security Appliance C170 사용자 가이드
Chapter 6 Email Security Manager
6-234
Cisco IronPort AsyncOS 7.1 for Email Configuration Guide
OL-22158-02
Step 3
“ex_employee”
This content filter will scan for messages sent to a specific envelope recipient
address (an ex-employee). If the message matches, a specific notification
message will be sent to the sender of the message and then the message will
be bounced.
address (an ex-employee). If the message matches, a specific notification
message will be sent to the sender of the message and then the message will
be bounced.
After creating the content filters, you will then configure each of the policies
(including the default policy) to enable the specific content filters in differing
combinations.
(including the default policy) to enable the specific content filters in differing
combinations.
Scan for Confidential
The first example content filter contains one condition and two actions. To create
the content filter:
the content filter:
Step 1
Click the Mail Policies tab.
Step 2
Click the Incoming Content Filters Section.
The Incoming Content Filters page is displayed. On newly installed or
upgraded systems, no content filters are defined by default.
upgraded systems, no content filters are defined by default.
Figure 6-17
Incoming Content Filters Page
Step 3
Click the Add Filter button.
The Add Content Filter page is displayed.
Step 4
In the Name field, type
scan_for_confidential
as the name of the new filter.
Filter names can contain ASCII characters, numbers, underscores or dashes.
The first character of a content filter name must be a letter or an underscore.
The first character of a content filter name must be a letter or an underscore.
Step 5
In the Description field, type the description. For example:
scan all incoming
mail for the string ‘confidential’
.
Step 6
Click Add Condition.
Step 7
Select Message Body.