Cisco Cisco Aironet 340 Ethernet Bridges 사용자 가이드
Configuring the Ethernet Port 5 - 3
NOTE: After the parameter is changed, the unit must be restar ted either
by powering it “Off” and then “On,” or by using the “Diagnostics Restar t”
command for the change to occur.
Setting the Port Interface Type (Port)
If this parameter is set to “Auto”, the Aironet 340 Series Bridge will
scan for a cable at all three connections. When the bridge is wired to an
Ethernet card that also scans, this parameter should be set to the port
that is being configured. You may select AUI for 10base5 for thicknet,
10baseT for twisted pair, or 10base2 for coax and thinnet.
scan for a cable at all three connections. When the bridge is wired to an
Ethernet card that also scans, this parameter should be set to the port
that is being configured. You may select AUI for 10base5 for thicknet,
10baseT for twisted pair, or 10base2 for coax and thinnet.