Cisco Cisco Aironet 1200 Access Point 릴리즈 노트
7
Release Notes for Cisco Aironet 1130AG, 1200, 1230AG, and 1240AG Series Access Points for Cisco IOS Release 12.3(7)JX9
OL-14252-01
Important Notes
Important Notes
This section describes important information about the access point.
Default Username and Password Are Cisco
You must enter a username and password when you log into an access point interface. The default
username for administrator login is Cisco, and the default password is Cisco. Both the username and
password are case sensitive.
username for administrator login is Cisco, and the default password is Cisco. Both the username and
password are case sensitive.
Cisco IOS Release 12.3(7)JX9 Supports 2006 and 4400 Controllers Only
When you load this release on an access point, the access point can communicate with Cisco 2006 series
wireless LAN controllers or 4400 series controllers only. Cisco 4100 series, Airespace 4012 series, and
Airespace 4024 series controllers are not supported because lack the memory required to support access
points running Cisco IOS software.
wireless LAN controllers or 4400 series controllers only. Cisco 4100 series, Airespace 4012 series, and
Airespace 4024 series controllers are not supported because lack the memory required to support access
points running Cisco IOS software.
Access Points Converted to LWAPP do not Support WDS
Access points converted to LWAPP mode communicate only with Cisco wireless LAN controllers and
cannot communicate with WDS devices. However, the controller provides functionality equivalent to
WDS when the access point associates to it.
cannot communicate with WDS devices. However, the controller provides functionality equivalent to
WDS when the access point associates to it.
Access Points Converted to LWAPP Support 8 BSSIDs per Radio
Access points converted to LWAPP mode support 8 BSSIDs per radio and a total of 8 wireless LANs per
access point. (Cisco 1000 series access points support 16 BSSIDs per radio and 16 wireless LANs per
access point.) When a converted access point associates to a controller, only wireless LANs with IDs 1
through 8 are pushed to the access point.
access point. (Cisco 1000 series access points support 16 BSSIDs per radio and 16 wireless LANs per
access point.) When a converted access point associates to a controller, only wireless LANs with IDs 1
through 8 are pushed to the access point.
Access Points Converted to LWAPP do not Support Layer 2 LWAPP
Access Points converted to LWAPP must get an IP address and discover the controller using DHCP,
DNS, or IP subnet broadcast.
DNS, or IP subnet broadcast.
Access Points Converted to LWAPP Provide Read-Only Console Port
After you convert an access point to LWAPP mode, the console port provides read-only access to the
unit.
unit.