Cisco Cisco Aironet 1240 AG Access Point 설치 가이드
3
Quick Start Guide Cisco Aironet 1240AG Series Access Point
Before You Start
Before you install the access point, make sure that you are using a computer
connected to the same network as the access point, and obtain the following
from your network administrator:
connected to the same network as the access point, and obtain the following
from your network administrator:
•
A host name for the access point
•
The case-sensitive SSID for your radio 802.11g and 802.11a radio
networks
networks
•
A Simple Network Management Protocol (SNMP) community name and
the SNMP file attribute (if SNMP is in use)
the SNMP file attribute (if SNMP is in use)
•
The Media Access Control (MAC) address from the label on the bottom
of the access point (such as 0016462584c), if you plan to use the Cisco
IP Setup Utility to find an access point IP address.
of the access point (such as 0016462584c), if you plan to use the Cisco
IP Setup Utility to find an access point IP address.
•
If you are not connected to a DHCP server, you can assign an IP address
to the access point using the CLI. In this situation, obtain a unique IP
address for your access point, a default gateway, and subnet mask from
your network system administrator.
to the access point using the CLI. In this situation, obtain a unique IP
address for your access point, a default gateway, and subnet mask from
your network system administrator.