Cisco Cisco Aironet 1240 AG Access Point 설치 가이드
46
OL-16714-01
Resetting to Default Configuration
If you forget your password that allows you to configure the access point, you
might need to completely reset the configuration. You can use the MODE
button on the access point to reset the configuration.
might need to completely reset the configuration. You can use the MODE
button on the access point to reset the configuration.
Note
These steps reset all configuration settings to factory defaults,
including passwords, WEP keys, the IP address, and the SSID.
including passwords, WEP keys, the IP address, and the SSID.
Using the MODE Button
Follow these steps to delete the current configuration and return all access
point settings to the factory defaults by using the MODE button:
point settings to the factory defaults by using the MODE button:
1.
Disconnect power from the access point (the power jack for external
power or the Ethernet cable for in-line power).
power or the Ethernet cable for in-line power).
2.
Press and hold the MODE button while you reconnect power to the
access point.
access point.
3.
Continue pressing the MODE button until the Ethernet LED turns amber.
(approximately 2 to 3 seconds). Then release the button.
(approximately 2 to 3 seconds). Then release the button.
4.
After the access point reboots, you must reconfigure it using the web
browser interface, the Telnet interface, or the access point console port.
browser interface, the Telnet interface, or the access point console port.