Cisco Cisco Aironet 1200 Access Point 설치 가이드
22
Installing a 5-GHz Radio Module
Caution
Before installing a 5-GHz radio module, verify that the access
point is running the proper firmware. The RM20A radio module
is VxWorks-based and must be running version 11.54T or later.
The RM21A and RM22A is Cisco IOS-based and must be
running 12.3(2)JA or later. If your access point is running
earlier firmware versions, it will not recognize the 5-GHz radio.
point is running the proper firmware. The RM20A radio module
is VxWorks-based and must be running version 11.54T or later.
The RM21A and RM22A is Cisco IOS-based and must be
running 12.3(2)JA or later. If your access point is running
earlier firmware versions, it will not recognize the 5-GHz radio.
Follow these steps to install a 5-GHz radio module in your access point.
1.
Make sure the module access cover on the access point is removed.
2.
Place the access point on a flat surface so that it is upright with its front
end facing you.
end facing you.
3.
Grasp the new 5-GHz module by its base with the antenna pointing up,
and insert the card into the access point card bus slot. The following
illustration shows the integrated antenna version.
and insert the card into the access point card bus slot. The following
illustration shows the integrated antenna version.