Cisco Cisco Aironet 1250 Series Access Point 설치 가이드

The operating frequency in a Wireless LAN is determined by the access point. As such, it is important 
that the access point is correctly configured to meet the local regulations. See the 

 

for the country specific operating frequency ranges.

In case of the AIR-RM1252G-E-K9 or AIR-RM1252A-E-K9 it is assumed that these modules have been 
mounted in an AIR-AP1250 or AIR-LAP1250 platform.

To change the output power of autonomous 1250 series access points (AIR-AP1252AG-E-K9, 
AIR-AP1252G-E-K9, or AIR-AP1250) follow these instructions:

Use your web-browser to access your access point.

Administrator privileges may be required in order to change access point settings.

When the Summary Status page displays, click Radio0-802.11N

 or Radio1-802.11N

.

On the radio status page, click Settings and the radio settings page displays.

Click the desired output power level in the Transmitter Power (Current Power) field.

Scroll down to the bottom of the page and click Apply.

Close your web-browser.

The output power on the AIR-LAP1252AG-E-K9, AIR-LAP1252G-E-K9, and AIR-LAP1250 access 
points can only be changed using a Cisco Wireless LAN 2100 or 4400 Series Controller, or the 
controllers on a Wireless Services Module (WiSM).

See the Cisco WLAN Controller Configuration Guide for your Wireless LAN Controller for more details 
on how to to configure your access point using the web-browser interface. 

Administrator privileges might be required in order to change controller settings.

The access point must be registered with your controller before you can make any configuration changes.