Cisco Cisco Aironet 701e Access point 설치 가이드

This product relies on the building’s installation for short-circuit (overcurrent) 
protection. Ensure that the protective device is rated not greater than: 
20A. Statement 1005

Do not operate your wireless network device near unshielded blasting caps or in an 
explosive environment unless the device has been modified to be especially qualified for 
such use. Statement 245B

In order to comply with FCC radio frequency (RF) exposure limits, antennas should be 
located at a minimum of 7.9 inches (20 cm) or more from the body of all persons. 
Statement 332

Do not use plastic wall anchors to mount the access point on a ceiling because they will 
not support the weight of the access point. The fasteners used must be capable of 
maintaining a minimum pullout force of 20 lbs (9 kg).

This product and all interconnected equipment must be installed indoors within the same 
building, including the associated LAN connections as defined by Environment A of the 
IEEE 802.af Standard.

Use only with listed ITE equipment.

Cisco Aironet 701E access points are designed for indoor use. If you install the access points 
in an enclosure, make sure the enclosure is designed to maintain an operating temperature 
between 32 and 104 degrees F (0 and 40 degrees C) and a humidity range between 10% and 
90% (noncondensing). Failure to maintain these temperature and humidity ranges can cause 
the unit to fail and void your warranty.