Cisco Cisco Aironet 701e Access point 설치 가이드
8
Step 1
Make sure that the Cisco wireless LAN controller DS port is connected to the network. Use
the CLI, web-browser interface, or Cisco Prime Infrastructure procedures as described in the
appropriate Cisco wireless LAN controller guide.
the CLI, web-browser interface, or Cisco Prime Infrastructure procedures as described in the
appropriate Cisco wireless LAN controller guide.
a.
Make sure that access points have Layer 3 connectivity to the Cisco wireless LAN controller
Management and AP-Manager Interface.
Management and AP-Manager Interface.
b.
Configure the switch to which your access point is to attach. See the Cisco Wireless LAN
Controller Configuration Guide for additional information.
Controller Configuration Guide for additional information.
c.
Set the Cisco wireless LAN controller as the master so that new access points always join with
it.
it.
d.
Make sure DHCP is enabled on the network. The access point must receive its IP address
through DHCP.
through DHCP.
e.
CAPWAP UDP ports (UDP 5246/5247) must not be blocked in the network.
f.
The access point must be able to find the IP address of the controller. This can be
accomplished using DHCP, DNS, or IP subnet broadcast. This guide describes the DHCP
method to convey the controller IP address. For other methods, refer to the product
documentation. See also the
accomplished using DHCP, DNS, or IP subnet broadcast. This guide describes the DHCP
method to convey the controller IP address. For other methods, refer to the product
documentation. See also the
for more
information.
Step 2
Apply power to the access point:
a.
The AP-701E access point is 802.3af (15.4 W) compliant and can be powered by any
802.3af-compliant device. The recommended external power supply for the access point is
the Cisco AIR-PWRINJ5= power supply.
802.3af-compliant device. The recommended external power supply for the access point is
the Cisco AIR-PWRINJ5= power supply.
Note
The access point requires a Fast Ethernet link to prevent the Ethernet port from
becoming a bottleneck for traffic because wireless traffic speeds exceed transmit
speeds of a 10Mbps Ethernet port.
becoming a bottleneck for traffic because wireless traffic speeds exceed transmit
speeds of a 10Mbps Ethernet port.
b.
As the access point attempts to connect to the controller, the LEDs cycle through a green, red,
and amber sequence, which can take up to 5 minutes.
and amber sequence, which can take up to 5 minutes.
Note
If the access point remains in this mode for more than five minutes, the access point is
unable to find the Master Cisco wireless LAN controller. Check the connection between
the access point and the Cisco wireless LAN controller and be sure that they are on the
same subnet.
unable to find the Master Cisco wireless LAN controller. Check the connection between
the access point and the Cisco wireless LAN controller and be sure that they are on the
same subnet.
c.
If the access point shuts down, check the power source.