Cisco Cisco Aironet 3600i Access Point 설치 가이드

You should have the following information about your wireless network available:

Access point locations.

Access point mounting options: below a suspended ceiling, on a flat horizontal surface, or on a desktop.

You can mount the access point above a suspended ceiling but you must purchase additional mounting hardware: 
See 

 for additional information.

Access point power options: power supplied by the recommended external power supply (Cisco AIR-PWR-B), a DC power 
supply, PoE from a network device, or a PoE power injector/hub (usually located in a wiring closet).

Access points mounted in a building’s environmental airspace must be powered using PoE to comply with safety 
regulations.

Cisco recommends that you make a site map showing access point locations so that you can record the device MAC addresses 
from each location and return them to the person who is planning or managing your wireless network.

Installing the access point involves these operations:

Performing a pre-installation configuration (optional)

Mounting the access point

Grounding the access point

Deploying the access point on the wireless network

The following procedures ensure that your access point installation and initial operation go as expected. A pre-installation 
configuration is also known as priming the access point. This procedure is optional.

Performing a pre-installation configuration is an optional procedure. If your network controller is properly configured, 
you can install your access point in its final location and connect it to the network from there. See the 

 for details.

The pre-installation configuration setup is shown in 

.