Cisco Cisco Aironet 3700p Access Point 설치 가이드

If the pre-installation configuration is successful, the Status LED is green indicating normal 
operation. Disconnect the access point and mount it at the location at which you intend to 
deploy it on the wireless network.

If your access point does not indicate normal operation, turn it off and repeat the 
pre-installation configuration.

When you are installing a Layer 3 access point on a different subnet than the Cisco 
wireless LAN controller, be sure that a DHCP server is reachable from the subnet on 
which you will be installing the access point, and that the subnet has a route back to 
the Cisco wireless LAN controller. Also be sure that the route back to the Cisco 
wireless LAN controller has destination UDP ports 5246 and 5247 open for CAPWAP 
communications. Ensure that the route back to the primary, secondary, and tertiary 
wireless LAN controller allows IP packet fragments. Finally, be sure that if address 
translation is used, that the access point and the Cisco wireless LAN controller have 
a static 1-to-1 NAT to an outside address. (Port Address Translation is not 
supported.)

Cisco Aironet 3702 series access points can be mounted in several configurations, including on a 
suspended ceiling, on a hard ceiling or wall, on an electrical or network box, and above a suspended 
ceiling. Click this URL to browse to complete access point mounting instructions:

After you have mounted the access point, follow these steps to deploy it on the wireless network:

Connect and power up the access point.