Cisco Cisco Aironet 3500i Access Point 데이터 시트

The antenna can be mounted on a pole or mast using two U-bolts (not provided).

Cisco recommends using a guillotine-style U-bolt or a U-bolt with a 
notched, toothed backing plate to ensure proper support and permanent 
positioning.

To mount the antenna on a pole or mast, follow these steps.

The pole or mast must be rigid enough to hold the weight of the antenna 
plus the associated forces produced by wind loads.  In addition, the mast 
must be structurally strong enough to withstand the clamping force of the 
U-bolts.

Follow steps 1 through 4 from 

: Remove the 

antenna and bracket from the shipping container, move the adjustment bolt from 
the shipping position to the adjustment slot, and select a mounting location.

Position the antenna, mounting bracket, and U-bolts on the mast.

Tighten the U-bolts until the antenna is secure on the mast.

Once the antenna is secured on the mast, you can adjust the azimuth and elevation. 

To adjust the azimuth and elevation, use a 10-mm wrench to loosen the adjustment 
bolts and the main pivot bolt (

). Azimuth can be adjusted ±60 degrees and 

elevation can be adjusted ±60 degrees.

After you adjust the antenna position, tighten the adjustment bolts and the pivot 
bolts. Tighten all bolts to 7 ± 0.5 lb-ft. (9.5 Nm).

Connect the antenna cable to the access point.