Cisco Cisco Aironet 1200 Access Point 릴리즈 노트
4
Release Notes for Cisco Aironet Access Points and Bridges for Cisco IOS Release 12.3(8)JEC3 and 12.4(10b)JDA3
OL-19981-01
New Features
Figure 1
Network Interfaces: Radio Settings Page
Step 2
Select Disable to disable the radio.
Step 3
Click Apply at the bottom of the page.
Step 4
If your access point has two radios, repeat these steps for the second radio.
Beginning in privileged EXEC mode, follow these steps to disable the access point radios using the CLI:
If your access point has two radios, repeat these steps for the second radio. Use the no form of the
shutdown command to enable the radio.
shutdown command to enable the radio.
New Features
There are no new features in this release.
Important Notes
This section describes important information pertaining to Cisco IOS Release 12.3(8)JEC3 and
12.4(10b)JDA3. A complete list may be found on Cisco.com at the following URL:
12.4(10b)JDA3. A complete list may be found on Cisco.com at the following URL:
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
interface dot11radio {0 | 1}
Enter interface configuration mode for the radio interface. The
2.4-GHz radio is radio 0, and the 5-GHz radio is radio 1.
2.4-GHz radio is radio 0, and the 5-GHz radio is radio 1.
Step 3
shutdown
Disable the radio port.
Step 4
end
Return to privileged EXEC mode.
Step 5
copy running-config startup-config (Optional) Save your entries in the configuration file.