Cisco Cisco Packet Data Gateway (PDG) 문제 해결 가이드
MME Service Configuration Mode Commands
esm ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22948-01
Timer
State
Cause of Start
Normal Stop
On Expiry1st, 2nd, 3rd, 4th
EXPIRY (NOTE 1)
EXPIRY (NOTE 1)
T3485 BEARER
CONTEXT
ACTIVE
PENDING
ACTIVE
PENDING
ACTIVATE
DEFAULT EPS
BEARER CONTEXT
REQUEST sent
DEFAULT EPS
BEARER CONTEXT
REQUEST sent
ACTIVATE
DEDICATED EPS
BEARER CONTEXT
REQUEST sent
DEDICATED EPS
BEARER CONTEXT
REQUEST sent
ACTIVATE DEFAULT
EPS BEARER
CONTEXT ACCEPT
received or
EPS BEARER
CONTEXT ACCEPT
received or
ACTIVATE DEFAULT
EPS BEARER
CONTEXT REJECT
received or
EPS BEARER
CONTEXT REJECT
received or
ACTIVATE
DEDICATED EPS
BEARER CONTEXT
ACCEPT received or
DEDICATED EPS
BEARER CONTEXT
ACCEPT received or
ACTIVATE
DEDICATED EPS
BEARER CONTEXT
REJECT received
DEDICATED EPS
BEARER CONTEXT
REJECT received
Retransmission of the
same message
same message
T3495 BEARER
CONTEXT
INACTIVE
PENDING
INACTIVE
PENDING
DEACTIVATE EPS BEARER
CONTEXT REQUEST sent
CONTEXT REQUEST sent
DEACTIVATE EPS BEARER
CONTEXT ACCEPT received
CONTEXT ACCEPT received
Retransmission of
DEACTIVATE EPS
BEARER CONTEXT
REQUEST
DEACTIVATE EPS
BEARER CONTEXT
REQUEST
NOTE 1: Typically, the procedures are aborted on the fifth expiry of the relevant timer. Exceptions are described in the
corresponding procedure description.
corresponding procedure description.
This command can be repeated to set each timer as needed.
The retransmission of all type of NAS messages can be configured through
The retransmission of all type of NAS messages can be configured through
command.
Example
The following command sets the timeout value for default EPS bearer context activation procedure timer T3485 for 10
seconds.
The following command sets the timeout value for default EPS bearer context activation procedure timer T3485 for 10
seconds.