Cisco Cisco Packet Data Gateway (PDG) 문제 해결 가이드
SGSN Operator Policy Configuration Mode Commands
attach ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22948-01
Instructs the SGSN to apply the command action to all location areas.
This keyword identifies a location area list already created with the
command.
The location area list consists of one or more LACs, location area codes, where the MS is when placing the
call. Using this keyword with either the
call. Using this keyword with either the
or
keywords enables you to configure with more
granularity.
must be an integer between 1 and 5.
Specify a GMM failure cause code to identify the reason an attach did not occur. This GMM cause code will
be sent in the reject message to the MS.
be sent in the reject message to the MS.
must be an integer from 2 to 111. Default is 14. Refer to the GMM failure cause codes listed
below (information has been taken from section 10.5.5.14 of the 3GPP TS 124.008 v7.2.0 R7):
2 - IMSI unknown in HLR
3 - Illegal MS
6 - Illegal ME
7 - GPRS services not allowed
8 - GPRS services and non-GPRS services not allowed
9 - MSID cannot be derived bythe network
10 - Implicitly detached
11 - PLMN not allowed
12 - Location Area not allowed
13 - Roaming not allowed in this location area
14 - GPRS services not allowed in this PLMN
15 - No Suitable Cells In Location Area
16 -MSC temporarily not reachable
17 - Network failure
20 - MAC failure
21 - Synch failure
22 - Congestion
23 - GSM authentication unacceptable
40 - No PDP context activated
48 to 63 - retry upon entry into a new cell
95 - Semantically incorrect message
96 - Invalid mandatory information
97 - Message type non-existent or not implemented
98 - Message type not compatible with state
99 - Information element non-existent or not implemented