Cisco Cisco Packet Data Gateway (PDG) 문제 해결 가이드
Channelized Port Configuration Mode Commands
threshold high-activity ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22948-01
threshold high-activity
Configures the port‘s high and low activity thresholds.
Product
SGSN
Privilege
Security Administrator, Administrator
Syntax
Default: 50
Sets the threshold for the highest percentage of port activity that must be met or exceeded, within the polling
interval, to generate an alert or alarm.
Sets the threshold for the highest percentage of port activity that must be met or exceeded, within the polling
interval, to generate an alert or alarm.
can be configured to any integer value between 0 and 100.
Default: 50
Sets the threshold for the lowest percentage level of port activity that must be met to generate and send a clear
alarm. If port activity does not drop to or below this threshold then the alarm is maintained.
Sets the threshold for the lowest percentage level of port activity that must be met to generate and send a clear
alarm. If port activity does not drop to or below this threshold then the alarm is maintained.
can be configured to any integer value between 0 and 100.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
High port activity thresholds generate alerts or alarms based on the utilization percentage of each configured
port during the specified polling interval. This threshold is configured on a per-port basis.
Alerts or alarms are triggered for high port activity based on the following rules:
port during the specified polling interval. This threshold is configured on a per-port basis.
Alerts or alarms are triggered for high port activity based on the following rules:
Enter condition: Actual percent utilization of a port ³ High Threshold
Clear condition: Actual percent utilization of a port < Low Threshold
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
Refer to the
of the polling interval.
Refer to the
command in the Global Configuration Mode Commands chapter of this
reference to configure the polling interval and the
command in this chapter to
enable thresholding for this value.
Example
The following command configures a high port utilization threshold percent of 70 and a low threshold of 50 for an
system using the Alarm thresholding model:
The following command configures a high port utilization threshold percent of 70 and a low threshold of 50 for an
system using the Alarm thresholding model: