Cisco Cisco Packet Data Interworking Function (PDIF) 문제 해결 가이드
Tunnel Interface Configuration Mode Commands
▀ ipv6 address
▄ Cisco ASR 5000 Series Command Line Interface Reference
OL-22948-01
ipv6 address
This command configures the IPv6 address for the specific tunnel interface.
Product
All
Privilege
Security Administrator, Administrator
Syntax
Removes the configured IPv6 address bound to a tunnel interface.
Specifies a destination IP address or group of addresses that will use this route.
: Specifies a combined IP address subnet mask bits to indicate what IP
addresses to which the route applies.
must be specified using the form ‗IP
Address/Mask Bits‘ where the IP address is specified using the standard IPv4 dotted decimal notation and the
mask bits are a numeric value which is the number of bits in the subnet mask.
mask bits are a numeric value which is the number of bits in the subnet mask.
Usage
Use this command to bind the IPv6 address to a tunnel interface. This address does not affect the
encapsulation of packets going out on the tunnel interface.
encapsulation of packets going out on the tunnel interface.
Example
The following command will assign the
The following command will assign the
as IPv4 address to this tunnel interface: