Cisco Cisco Packet Data Gateway (PDG) 문제 해결 가이드
ACS Rulebase Configuration Mode Commands
route priority ▀
Cisco ASR 5000 Series Command Line Interface Reference ▄
OL-22947-02
Analyzer
Common ways to route to the analyzer
FTP and the command name is retr or stor; or, HTTP and the request method is get or post.
WSP content type is application/vnd.wap.mms-message; or, WSP uri contains ―mms‖; or, HTTP content type is
application/vnd.wap.mms-message; or, HTTP uri contains ―mms‖.
application/vnd.wap.mms-message; or, HTTP uri contains ―mms‖.
UDP destination port or source port is SIP (5060).
RTSP or SIP content type is application/sdp
TCP destination port or source port is SMTP (25).
TCP destination port or source port is IMAP (143).
TCP destination port or source port is POP3 (110).
and
RTSP has embedded RTP/RTCP payloads (you need to enable RTP dynamic flow detection to catch those flows);
or, RTSP or SDP (for SDP within SIP) creates an RTP/RTCP flow over UDP (in addition to enabling the
aforementioned dynamic flow detection, you must make sure that UDP packets are routed to the UDP analyzer)
or, RTP/RTCP uses predefined UDP port numbers (e.g. default UDP port numbers of 5004/5005).
or, RTSP or SDP (for SDP within SIP) creates an RTP/RTCP flow over UDP (in addition to enabling the
aforementioned dynamic flow detection, you must make sure that UDP packets are routed to the UDP analyzer)
or, RTP/RTCP uses predefined UDP port numbers (e.g. default UDP port numbers of 5004/5005).
TCP destination port or source port is RTSP (554).
Use the
CLI command to enable detection of the different P2P
applications specified by the
CLI command; that will cause every TCP or UDP packet to
be automatically routed here
Example
The following command assigns a route and rule action with the route priority of 23, a ruledef named
The following command assigns a route and rule action with the route priority of 23, a ruledef named
, and an
analyzer
with description as
to the current rulebase: