Cisco Cisco Aironet 1400 Wireless Bridge 릴리즈 노트

This section contains important information to keep in mind when installing your bridge.

The bridge is available in two configurations:

Integrated antenna bridge (with 22.5-dBi directional antenna)

External antenna bridge (with antenna connector for use with an external antenna)

To meet regulatory restrictions, the external antenna bridge configuration and the external antenna must 
be professionally installed.

When installing the dual-coax cable, it is acceptable to unzip or pull the two cables apart at the ends if 
more separation is needed between the male F connectors. 

Personnel installing the bridge must understand wireless bridging techniques, antenna alignment and 
adjustment, and grounding methods. The integrated antenna configuration can be installed by an 
experienced IT professional. 

You can double the throughput or create a standby link by stacking two bridges. A stacked installation 
consists of two bridge systems installed at the same physical location. For detailed mounting instructions 
refer to the Cisco Aironet 1400 Series Wireless Bridge Mounting Instructions that shipped with your 
bridge.

The bridge antennas must be separated by a minimum of 6.56 ft (2 m) from each other and from other 
co-located antennas.

This section describes important information about the bridge.

If the bridge’s SSID has not been changed from the default setting and you select Install Automatic 
Mode as the bridge’s role in radio network setting, the SSID automatically changes from tsunami to 
autoinstall. When you change the role in radio network from Install Automatic Mode to Root or 
Non-Root, the SSID changes automatically from autoinstall back to tsunami. However, if you change 
the SSID from its default setting, changing the role in radio network setting does not change the SSID.