Cisco Cisco Aironet 1400 Wireless Bridge 릴리즈 노트

Medium blinking rate of 2 blinks per second.

Fast blinking rate of 4 blinks per second.

The Install LED starts to blink amber to indicate that the bridge is searching for a root bridge.

When the bridge associates to a root bridge, the Install LED turns amber.

When the bridge becomes a root bridge and is waiting for a non-root bridge to associate, the Install 
LED blinks green.

When the root bridge has a non-root bridge associated, the Install LED turns green.

Do not attempt to load software images into the bridge from both a Telnet session and console session 
simultaneously. The bridge cannot detect that two images are being loaded at the same time. For best 
results, use the archive download command in the CLI.

The bridge sometimes cannot detect invalid software images when you load software using the copy 
command. For best results, use the archive download command in the CLI to load new software.

When the bridge is transmitting and receiving heavy traffic, you sometimes cannot start a Telnet session 
and some existing Telnet sessions freeze or hang. However, this behavior is expected because the bridge 
gives top priority to data traffic and a lower priority to Telnet traffic.

This section lists open and resolved caveats for the bridge.

These caveats are open in Cisco IOS Release 12.3(8)JEA:

CSCed36462—Per-VLAN crypto settings are nonfunctional with wireless bridges.

On wireless bridges, all VLANs traversing the bridge link must use the same encryption settings. To 
avoid confusion, do not use the “vlan <vlan-id> keyword on the encryption command as shown in 
the following example:

interface dot11radio0

encryption key 1 size 128bit AAAAABBBBBCCCCCDDDDDEEEEEF transmit-key

encryption mode wep mandatory mic