Cisco Cisco Aironet 350 Access Points 릴리즈 노트

You can upgrade the Access Point firmware, distribute new firmware to other Access Points, and 
distribute a specific configuration to other Access Points. Consult Chapter 5, “Maintaining Firmware” in the Cisco Aironet Access Point Software Configuration Guide for more information.

You can assign the Access Point to act as a backup for another Access Point to provide uninterrupted 
network connectivity in case an Access Point malfunctions. Consult the “Using Hot Standby Mode” section on page 7-5 of the Cisco Aironet Access Point Software Configuration Guide for more 
information.

With world mode enabled, the Access Point provides radio channel settings for client devices that 
associate with the Access Point. A visitor from Japan using world mode on a client device can associate 
with an Access Point in California and automatically switch to the correct channel settings. Consult the 
“Enable World Mode” section on page 3-34 of the Cisco Aironet Access Point Software Configuration 
Guide for more information.

The Access Point provides information on number of users, bit error rates, and signal strength to client 
devices, and the clients select the Access Point that provides the best network connection.

When you select yes for Search for less-congested radio channel on the management system’s AP Radio 
Hardware page, the Access Point scans for the radio channel that is least busy and selects that channel 
for use. The Access Point scans at power-up and when the radio settings are changed. Consult the 
“Settings on the AP Radio Hardware Page” section on page 3-33 of the Cisco Aironet Access Point 
Software Configuration Guide for more information.

You can find the latest release of Access Point firmware at the following URL:

http://www.cisco.com/pcgi-bin/tablebuild.pl/aironet-340

The operational voltage range for Cisco Aironet 350 series Access Points is 24 to 60 VDC. 
Higher voltage can damage the equipment.

Cisco Aironet power injectors are designed for use with 350 series Access Points and 
bridges only. Do not use the power injector with any other Ethernet-ready device. 
Using the power injector with other Ethernet-ready devices can damage the equipment.