Cisco Cisco Aironet 350 Access Points 릴리즈 노트

Click Apply or OK.

SNMP community name must include extra privilege to access all information (CSCdt31925).

SNMP community names entered on the Express Setup page have limited access to the access 
point’s configuration information. To provide full access to the SNMP community you specify on 
the Express Setup page, use the User Manager pages to assign firmware privilege to the community 
name. Refer to the Cisco Aironet Access Point Software Configuration Guide for complete 
instructions on using the User Manager. Refer to the Cisco Aironet Access Point Software 
Configuration Guide for more information on using the User Manager.

Filters can be disabled but not edited from the command-line interface (CSCdt34104). 

You cannot edit MAC address filters with the command-line interface. However, you can use the 
CLI’s Ethernet Protocol Filters and Root Radio Protocol Filters pages to disable filters.

Access point sometimes loads wrong firmware when updating from an FTP server (CSCdu38857).

When you update access point firmware through FTP file retrieval in the web-browser interface, the 
access point searches for any valid firmware files if it does not find the firmware file on the FTP 
server. If the access point finds a valid firmware file, it uses the alternate file and does not indicate 
on the web-browser interface that it is loading an alternate firmware image. After you update 
firmware through FTP file retrieval in the web-browser interface, check that the access point loaded 
the correct firmware version. The access point’s firmware version number appears in the upper-left 
corner of most management screens in the web-browser interface.

Web-browser interface sometimes requires multiple logins (CSCdu68659).

When User Manager is enabled and you browse to the Cisco Services Setup page, you must log into 
the User Manager system. If you browse from the Cisco Services Setup page to another restricted 
page, you must log in again. 

Settings for Require EAP and Default Unicast Filter missing from CLI (CSCdu74974).

On the CLI, the AP/Root Radio Advanced page does not contain the Require EAP and Default 
Unicast Address Filter settings. Use the web-browser interface to enter these settings.

For the most up-to-date, detailed troubleshooting information, refer to the Cisco TAC website at 

. Select Wireless LAN under Top Issues.