Cisco Cisco Aironet 1310 Access Point Bridge 릴리즈 노트

In this release, the radio or radios are disabled by default, and there is no default SSID. You must create 
an SSID and enable the radio or radios before the access point/bridge will allow wireless associations 
from other devices. These changes to the default configuration improve the security of newly installed 
access points and bridges.

If you use the mbssid configuration interface command to enable multiple BSSIDs on a specific radio 
interface but VLANs are not configured on the access point, the access point disables the radio interface. 
To re-enable the radio, you must shut down the radio, disable multiple BSSIDs, and re-enable the radio.

This example shows the commands you use to re-enable the radio:

AP(config)# interface d1

AP(config-if)# shut

AP(config-if)# no mbssid

AP(config-if)# no shut

After you re-enable the radio, you can enable VLANs on the access point and enable multiple BSSIDs.

Some wireless client devices, including Dell Axim handhelds and Hewlett-Packard iPaq HX4700 
handhelds, cannot associate to an access point when the access point is configured for QoS. To allow 
these clients to associate, disable QoS on the access point. You can use the QoS Policies page on the 
access point GUI to disable QoS, or enter this command on the CLI:

ap(config-if)#no dot11 qos mode

The proxy Mobile-IP feature is not supported in Cisco IOS Releases 12.3(2)JA and later.

Cisco IOS Release 12.3(4)JA1 does not support this feature.

Ethernet port settings on the access point/bridge must be set to auto speed and auto negotiation. If you 
use any other setting, the GUI operates very slowly.