Cisco Cisco Aironet 350 Access Points 릴리즈 노트

The operational voltage range for 350 series access points and bridges is 24 to 60 VDC, and the 
nominal voltage is 48 VDC. Voltage higher than 60 VDC can damage the equipment.

Cisco Aironet power injectors are designed for use with 350 series access points and 350 series 
bridges only. Do not use the power injector with any other Ethernet-ready device. Using the power 
injector with other Ethernet-ready devices can damage the equipment.

You must have a 340 or 350 series access point or a 350 series bridge to install firmware version 11.10T1.

Your access point must be running firmware version 10.x or later to install firmware version 11.10T1. 
Your bridge must be running version 11.07 or later to install firmware version 11.10T1.

The firmware version number is in the upper-left corner of most management screens in the web-browser 
interface and at the top of the home (Summary Status) page in the command-line interface.

For instructions on installing access point and bridge firmware:

Follow this link to the Cisco Aironet documentation home page:

http://www.cisco.com/univercd/cc/td/doc/product/wireless/index.htm

Follow this path to the product, document, and chapter:
Aironet 350 Series Wireless LAN Products > Cisco Aironet 350 Series Access Points > Cisco 
Aironet Access Point Software Configuration Guide > Maintaining Firmware > Updating Firmware

Follow this link to the Software Center on Cisco.com and download firmware version 11.10T1:

To upgrade firmware from a file server, you must enter settings on the access point’s or bridge’s FTP 
Server Setup page. Refer to the Cisco Aironet Access Point Software Configuration Guide for more 
information.