Cisco Cisco Aironet 1310 Access Point Bridge 릴리즈 노트
12
Release Notes for Cisco Aironet Access Points and Bridges for Cisco IOS Release 12.4(25d)JA2
OL-23880-01
Important Notes
Mask Field on IP Filters Page Behaves the Same As in CLI
In Cisco IOS Release 12.2(8)JA and later, the mask that you enter in the Mask field on the IP Filters page
in the access point GUI behaves the same way as a mask that you enter in the CLI. If you enter
255.255.255.255 as the mask, the access point accepts any IP address. If you enter 0.0.0.0, the access
point looks for an exact match with the IP address that you entered in the IP Address field.
in the access point GUI behaves the same way as a mask that you enter in the CLI. If you enter
255.255.255.255 as the mask, the access point accepts any IP address. If you enter 0.0.0.0, the access
point looks for an exact match with the IP address that you entered in the IP Address field.
Repeater Access Points Cannot Be Configured as WDS Access Points
Repeater access points can participate in WDS, but they cannot provide WDS. You cannot configure a
repeater access point as a main WDS access point, and if a root access point becomes a repeater in
fallback mode, it cannot provide WDS.
repeater access point as a main WDS access point, and if a root access point becomes a repeater in
fallback mode, it cannot provide WDS.
Cannot Perform Link Tests on Non-Cisco Aironet Client Devices and on Cisco
Aironet 802.11g Client Devices
Aironet 802.11g Client Devices
The link test feature on the web-browser interface does not support non-Cisco Aironet client devices nor
Cisco Aironet 802.11g client devices.
Cisco Aironet 802.11g client devices.
Corrupt EAP Packet Sometimes Causes Error Message
During client authentication, the access point sometimes receives a corrupt EAP packet and displays this
error message:
error message:
Oct 1 09:00:51.642 R: %SYS-2-GETBUF: Bad getbuffer, bytes= 28165
-Process= "Dot11 Dot1x process", ipl= 0, pid= 32
-Traceback= A2F98 3C441C 3C7184 3C604C 3C5E14 3C5430 124DDC
You can ignore this message.
When Cipher Is TKIP Only, Key Management Must Be Enabled
When you configure TKIP-only cipher encryption (not TKIP + WEP 128 or TKIP + WEP 40) on any
radio interface or VLAN, every SSID on that radio or VLAN must be set to use WPA or CCKM key
management. If you configure TKIP on a radio or VLAN but you do not configure key management on
the SSIDs, client authentication fails on the SSIDs.
radio interface or VLAN, every SSID on that radio or VLAN must be set to use WPA or CCKM key
management. If you configure TKIP on a radio or VLAN but you do not configure key management on
the SSIDs, client authentication fails on the SSIDs.
Cisco CKM Supports Spectralink Phones
Cisco CKM (CCKM) key management is designed to support voice clients that require minimal roaming
times. CCKM supports only Spectralink and Cisco 7920 Version 2.0 Wireless Phones. Other voice
clients are not supported.
times. CCKM supports only Spectralink and Cisco 7920 Version 2.0 Wireless Phones. Other voice
clients are not supported.