Cisco Cisco Aironet 1310 Access Point Bridge 릴리즈 노트
3
Release Notes for Cisco Aironet Access Points for Cisco IOS Release 12.3(11)JA4
OL-14258-01
System Requirements
Step 7
Click 12.3(11)JA4 > Wireless LAN > Download and the Software License Agreement page appears.
Step 8
Read the agreement, click Agree, and enter your username and password on the Log In screen.
Step 9
Follow the prompts to save the software on your PC.
Upgrading to a New Software Release
For instructions on installing new software for your bridge:
Step 1
Follow this link to the Cisco Software Center page:
Step 2
Scroll down to the Access point section.
Step 3
Choose your access point from the displayed list. The Cisco Aironet 1400 Series Introduction page
appears.
appears.
Step 4
Under the Configure section, click Configuration Guides. A list of configuration documents appears.
Step 5
Click Cisco IOS Software Configuration Guide for Cisco Aironet Access Points.
Step 6
Navigate to the Managing Firmware and Configurations chapter.
Disable Radios to Prevent Unexpected Reboot When Upgrading System Software
If your access point runs Cisco IOS Release 12.2(11)JA, 12.2(11)JA1, or 12.2(11)JA2, your access point
might unexpectedly reboot after you upgrade to a later Cisco IOS Release. Because of a rare timing
condition that affects the radios, the access point sometimes reboots immediately after the upgrade when
the radios are enabled. However, after the access point reboots the upgrade is complete and the access
point operates normally. To prevent the access point from rebooting unexpectedly, disable the radio
interfaces before upgrading software.
might unexpectedly reboot after you upgrade to a later Cisco IOS Release. Because of a rare timing
condition that affects the radios, the access point sometimes reboots immediately after the upgrade when
the radios are enabled. However, after the access point reboots the upgrade is complete and the access
point operates normally. To prevent the access point from rebooting unexpectedly, disable the radio
interfaces before upgrading software.
Follow these steps to disable the radio interfaces using the web-browser interface:
Step 1
Browse to the Network Interfaces: Radio Settings page.
shows the top portion of the Network
Interfaces: Radio Settings page.