Cisco Cisco Aironet 1310 Access Point Bridge 릴리즈 노트
5
Release Notes for Cisco Aironet Access Points for Cisco IOS Release 12.3(11)JA4
OL-14258-01
New Features
New Features
No new features are introduced in Cisco IOS Release 12.3(11)JA4.
Caveats
This section lists open and resolved caveats for access points.
Open Caveats
These caveats are open in Cisco IOS Release 12.3(11)JA4:
•
CSCsd99125— WDS may report an incorrect new channel to WLSE after a RADAR event
During DFS event testing, it was discovered that if a DFS event was triggered on a non-root device,
the WLSE sometimes received an erroneous new channel report.
the WLSE sometimes received an erroneous new channel report.
•
CSCsd90308—Large default beacon size causes blue screen on Conexant Wi-Fi station
The very large default beacon size on the 802.11a band with 12.3(11)JA firmware is causing a
Conexant ISL39200C with the Wi-Fi test bed driver to blue screen under Windows XP.
Conexant ISL39200C with the Wi-Fi test bed driver to blue screen under Windows XP.
The 802.11a beacon size of with TKIP, AES, and WMM enabled is approximately 285 bytes,
depending on the size of the SSID. This is an enormous jump in size since Cisco’s last version of
firmware due to the Country IE 7 and the Power Constraint IE now being advertised by default.
depending on the size of the SSID. This is an enormous jump in size since Cisco’s last version of
firmware due to the Country IE 7 and the Power Constraint IE now being advertised by default.
The Conexant radio seems to blue screen at 235 bytes and larger. Conexant has reproduced the
problem.
problem.
•
CSCse49342—DHCP_SERVER_FAILURE observed in 1300 series in WGB mode
•
CSCse48137—Nested repeater does not work
A nested 1130 access point configured for open authentication and root mode station role fails to
associate with a repeater and displays the following console message:
associate with a repeater and displays the following console message:
*Mar 1 00:01:34.822: %DOT11-4-CANT_ASSOC: Interface Dot11Radio1, cannot associate: No
Response
*Mar 1 00:02:17.603: %DOT11-6-DFS_SCAN_COMPLETE: DFS scan complete on frequency 5560
MHz
*Mar 1 00:02:31.821: %DOT11-4-CANT_ASSOC: Interface Dot11Radio1, cannot associate:
Rcvd response from 0014.6956.5cda channel 149 801
•
CSCse36333—Workgroup bridge client fails to get a DHCP IP address when root link is configured
for WPA v2 LEAP authentication
for WPA v2 LEAP authentication
A root access point and workgroup bridge access point configured for WPAv2 LEAP authentication
properly associate and authenticate, but the workgroup bridge client does not get an IP address from
the DHCP server. The root access point does not show the workgroup bridge client details.
properly associate and authenticate, but the workgroup bridge client does not get an IP address from
the DHCP server. The root access point does not show the workgroup bridge client details.
•
CSCse40389—Dot1x(LEAP) reauthentication occurs even though it is not enabled
A 3550 or 2950 switch continuously re-authenticates an access point on a specific interval though
re-authentication is disabled on the switch side when the dot1x method is LEAP.
re-authentication is disabled on the switch side when the dot1x method is LEAP.
Continuous re-authentication does occur when the dot1x authentication method is FAST.