Cisco Cisco Aironet 1310 Access Point Bridge 릴리즈 노트
6
Release Notes for Cisco Aironet Access Points for Cisco IOS Release 12.3(8)JEA2
OL-14260-01
Important Information
For complete instructions on using the conversion utility, refer to the Cisco Aironet Conversion Tool for
Cisco IOS Software, 2.1 Administrator Guide for Windows. Click this link to browse to the Administrator
Guide:
Cisco IOS Software, 2.1 Administrator Guide for Windows. Click this link to browse to the Administrator
Guide:
To download the conversion utility or the upgrade image, click this link to browse to the Cisco IOS
Software Center on Cisco.com:
Software Center on Cisco.com:
On the Cisco IOS Software Center page, enter your Cisco.com username and password to use the Feature
Navigator or the Cisco IOS Upgrade Planner, or click Wireless Software to go to the Wireless LAN
Software page. Download the conversion utility or the upgrade image for 350 or 1200 series access
points. You can also download instructions for using the utility and the upgrade image.
Navigator or the Cisco IOS Upgrade Planner, or click Wireless Software to go to the Wireless LAN
Software page. Download the conversion utility or the upgrade image for 350 or 1200 series access
points. You can also download instructions for using the utility and the upgrade image.
Some Fields Not Updated During Upgrade to IOS Software
When you upgrade an access point to run Cisco IOS software, some fields that are reported in the console
messages during the upgrade are blank or are populated with zeros. However, blank or zero fields are
normal after a successful upgrade, because 350 and 1200 series access points do not support that
information. This example shows fields that might appear blank or populated with zeros:
messages during the upgrade are blank or are populated with zeros. However, blank or zero fields are
normal after a successful upgrade, because 350 and 1200 series access points do not support that
information. This example shows fields that might appear blank or populated with zeros:
32K bytes of flash-simulated non-volatile configuration memory.
Base Ethernet MAC Address: 00:05:9A:38:42:91
Part Number: 0-0000-00
PCA Assembly Number: 000-00000-00
PCA Revision Number:
PCB Serial Number:
Top Assembly Part Number: 000-00000-00
Top Assembly Serial Number:
Top Revision Number:
Product/Model Number: AIR-AP352-IOS-UPGRD
Important Information
CCKM and Fast Roaming on Cisco 7921/7925 IP Phones
When a 7921 or 7925 wireless associates to an access point in a WDS with CCKM, it cannot fast roam
because call admission control is not enabled. To work around this issue you must enable admission
control by issuing the admit-traffic command in the access point SSID configuration as shown in the
following example:
because call admission control is not enabled. To work around this issue you must enable admission
control by issuing the admit-traffic command in the access point SSID configuration as shown in the
following example:
dot11 ssid voice
vlan 21
authentication open eap eap_methods
authentication network-eap eap_methods
authentication key-managemenet wpa cckm
admit-traffic