Cisco Cisco Aironet 350 Access Points 릴리즈 노트

CSCeb48645—Client devices in power-save mode no longer lock up when associated to an access 
point running Cisco IOS software.

CSCeb52239, CSCec20465—The access point now correctly assigns VLANs to devices connected 
to a workgroup bridge.

CSCeb60581—The access point now sends the correct username with RADIUS accounting packets.

CSCeb69596—You can now enter the letters in MAC addresses using either upper-case or 
lower-case letters when using the web-browser interface to configure MAC-address filtering or 
authentication.

CSCeb76171—The web-browser interface now displays pages correctly when a message-of-the-day 
(MOTD) banner is configured on the CLI.

CSCeb79465—The access point with a spectralink wireless phone now sends buffered data.

CSCeb87628—Client devices using PEAP authentication now authenticate successfully through the 
access point.

CSCeb87982—The access point now correctly displays hot standby status and event messages.

CSCec00308—Efficient Speedstream DHCP server now responds to Cisco IOS DHCP discover 
packets.

CSCec07703—Cisco 7920 IP Phones no longer drop calls when associated to 1100 and 1200 series 
access points.

CSCec12813—Client devices in power-save mode no longer lose packets when they wake up.

CSCec15572—You can now use the [no] boot upgrade global configuration command to configure 
the access point to boot without loading a configuration.

CSCec21082—The access point now reports accurate statistics for ifOutUcastPkts on radio 
interfaces.

CSCec29293—The access point no longer immediately drops all client associations when you enter 
the reload in minutes command.

CSCec39405—The following combination of radio settings no longer reduces throughput on the 
802.11a radio in 1200 series access points:

Fragmentation threshold set to 500

RTS threshold set to 256

WPA enabled 

CSCec43028—The access point CLI no longer displays 40-bit WEP keys as 128-bit WEP keys.

CSCin44512—If 8 or more VLANs are configured on your access point, you can now apply filters 
using the Apply Filters page in the web-browser interface. 

CSCin44591—PSPF now works when you use the web-browser interface to enable PSPF on a 
non-native VLAN. 

For the most up-to-date, detailed troubleshooting information, refer to the Cisco TAC website at 

. Click Technology Support, choose Wireless 

from the menu on the left, and click Wireless LAN.