Cisco Cisco Aironet 1310 Access Point Bridge 릴리즈 노트

When you ping or run a link test from an access point to a client device installed in a PC running 
Microsoft Windows 2000, the ping or link test sometimes fails when the client has both wired and 
wireless connections to the LAN. Microsoft does not recommend this configuration. For more 
information, refer to Microsoft Knowledge Base article 157025 at this URL:

Repeater access points and workgroup bridges cannot associate to an SSID configured for Layer 3 
mobility. Layer 3 mobility is not supported on repeaters and workgroup bridges.

You must use a Wireless LAN Services Module (WLSM) as your WDS device in order to properly 
configure Layer 3 mobility. If you enable Layer 3 mobility for an SSID and your WDS device does not 
support Layer 3 mobility, client devices cannot associate using that SSID.

This section lists open and resolved caveats for access points and bridges in Cisco IOS Release 
12.4(21a)JA1.

These caveats are open in Cisco IOS Release 12.4(21a)JA1:

CSCsv82129—Bad cookie error msg appears in workgroup bridge mode running open.

CSCsr79628— Number of supported BSSID not shown on access point GUI.

The show controllers command reports the number of BSSIDs supported:
“Number of supported simultaneous BSSID on Dot11RadioX: 1”

The above information cannot be seen in the access pont GUI.

CSCsv75779—Association ping link test page  in 1310 GUI produces an error message.

Workaround: None

CSCsv97205— 1310 bridge GUI “infrastructure clien” information is invisible.

Workaround: None