Cisco Cisco Aironet 350 Access Points 릴리즈 노트
8
Release Notes for Cisco Aironet 350, 1100, and 1200 Series Access Points for Cisco IOS Release 12.2(13)JA
OL-4529-01
Important Notes
Unpowered 1100 Series Access Points Cause Loopback When Connected to Switches Without
Loopback Detection
Loopback Detection
When you connect an unpowered 1100 series access point to a switch without loopback detection, the
access point causes a loopback. To avoid this problem, make sure loopback detection is enabled on the
switch to which the access point is connected. If your switch does not have loopback detection,
disconnect the access point from the switch when the access point power is off.
access point causes a loopback. To avoid this problem, make sure loopback detection is enabled on the
switch to which the access point is connected. If your switch does not have loopback detection,
disconnect the access point from the switch when the access point power is off.
Antenna Installation
For instructions on the proper installation and grounding of external antennas for 1200 series access
points, refer to the National Fire Protection Association’s NFPA 70, National Electrical Code, Article
810, and the Canadian Standards Association’s Canadian Electrical Code, Section 54.
points, refer to the National Fire Protection Association’s NFPA 70, National Electrical Code, Article
810, and the Canadian Standards Association’s Canadian Electrical Code, Section 54.
Warning
Do not install the antenna near overhead power lines or other electric light or power circuits, or
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, as they may cause serious injury or death.
where it can come into contact with such circuits. When installing the antenna, take extreme care
not to come into contact with such circuits, as they may cause serious injury or death.
Important Notes
This section describes important information about the access point.
Default Username and Password Are Cisco
When you open the access point interface, you must enter a username and password. The default
username for administrator login is Cisco, and the default password is Cisco. Both the username and
password are case sensitive.
username for administrator login is Cisco, and the default password is Cisco. Both the username and
password are case sensitive.
Access Points Do Not Support Loopback Interface
You must not configure a loopback interface on the access point.
Caution
Configuring a loopback interface might generate an IAPP GENINFO storm on your network.
Non-Cisco Aironet 802.11g Clients Might Require Firmware Upgrade
Some non-Cisco Aironet 802.11g client devices require a firmware upgrade before they can associate to
the 802.11g radio in the access point. If your non-Cisco Aironet 802.11g client device does not associate
to the access point, download and install the latest client firmware from the manufacturer’s website.
the 802.11g radio in the access point. If your non-Cisco Aironet 802.11g client device does not associate
to the access point, download and install the latest client firmware from the manufacturer’s website.