Cisco Cisco Aironet 350 Access Points 릴리즈 노트

Click General. The Proxy Mobile IP General page appears.

Change the Enable Proxy Mobile IP setting to no.

Add or delete AAPs as necessary. 

Change the Enable Proxy Mobile IP setting to yes.

When a Symbol IP phone is associated to a VoIP VLAN (Symbol extensions enabled), the phone 
associates to the access point and is authenticated approximately every 2 seconds. the Symbol phone 
shows a “No Network” error every 1 to 2 minutes. It also appears that Symbol phones do not work well 
when using a non-primary SSID. It is possible that the phone does not perform an active probe and 
therefore does not detect information about the SSID it associated with in the beacon, causing it to 
reassociate and authenticate.

Symbol phones may disconnect and be unable to roam between subnets when the access point passes 
multicast or FTP traffic. If there are no FTP or multicast sessions in progress the Symbol phone operates 
normally and is able to roam between subnets. To work around this issue, limit multicast and FTP traffic 
if you are using Symbol IP phones in a proxy Mobile IP environment.

Although the hot standby feature appears on the menu, hot standby is not supported on 350 series 
bridges.

This section lists open and resolved software issues in VxWorks firmware version 12.04.

If you are a registered Cisco user, you can use the Cisco TAC Software Bug Toolkit, which consists of 
three tools (Bug Navigator, Bug Watcher, and Search by Bug ID Number) that help you identify existing 
bugs (or caveats) in Cisco software products. Access the TAC Software Bug Toolkit at:

The following caveats have not been resolved for VxWorks firmware version 12.04:

CSCdz30285—The Configuring the Cisco Wireless Security Suite application note is incorrect.

The screen capture in section 3.1 of this document shows Add AAA Server, which is incorrect as 
the Aironet device is a client of the ACS, not a server.

Workaround: Call the TAC for setup instructions.